As the optical fiber laser cutting machine officially emerged in 2011, in the following years, the optical fiber laser cutting machine gradually occupied the entire cutting market with a trend of rapid development, and replaced the traditional CO2 laser cutting technology. With the continuous development of science and technology, Jinan has also been upgrading the optical fiber laser cutting in recent years. On the basis of 3000W, 6000W and higher power optical fiber laser cutting machines have also emerged as the times require. However, many people may not understand the difference between 6000W and 3000W optical fiber laser cutting machines. Today, let me take you to know.
Carbon steel bright surface cutting:
Analyzing the cutting thickness of the optical fiber laser cutting machine, the cutting thickness of the bright side of the 3000W optical fiber laser cutting machine is about 10MM; Compared with the 3000W optical fiber laser cutting machine, the bright surface cutting thickness of the 6000W optical fiber laser cutting machine is much greater than that of the 3000W optical fiber laser cutting machine. The bright surface thickness of the 6000W optical fiber laser cutting machine is less than 16MM, and can be cut with fast cutting speed and good perpendicularity.
Carbon steel full power cutting:
Full power cutting is 100% power cutting. The 6000W optical fiber laser cutting machine has the advantages of high electro-optical conversion efficiency, good beam quality and high power density. In actual operation, because the 6000W optical fiber laser cutting machine has full power cutting capacity, fast cutting speed, small taper and other advantages, the 6000W optical fiber laser cutting machine can be used for cutting carbon steel materials with the thickness of 16-25mm.
Stainless steel cutting:
Compared with 3000W fiber laser cutting machine, the whole 6000W fiber laser cutting machine conforms to the safety standards for laser equipment in developed countries in Europe and the United States, and uses laser beam cutting. Compared with 3000W fiber laser cutting machine, the cutting speed of 6000W fiber laser cutting machine can be increased by 140%~330%, which can effectively improve the working efficiency.
Cutting without burr:
The common laser cutting machines use oxygen or nitrogen for operation. When the section requirements are not high, the optical fiber laser cutting machine can also use air for cutting on this basis. The air is compressed to the storage tank by the air compressor, and can be used after being cooled and dried by the filter cooler. In this way, the user's use cost can be effectively reduced.
Among the optical fiber laser cutting machines of the same brand, the 3000W laser cutting machine can cut 2.5 mm thick carbon steel and 10 mm stainless steel materials without burrs; In contrast, 6000W can cut 5mm thick carbon steel and 16mm thick stainless steel materials without burrs. Among the same brand and type of optical fiber laser cutting machines, 6000W laser cutting machines can process materials with a thickness far greater than 3000W laser cutting machines.
