Inspection of the optical path: The optical path system of the machine is reflected by the reflection 1. The X-axis guide and lead screw, Y-axis guide and lead screw, Z-axis guide and lead screw must be checked every other week to keep the lubrication of all moving parts. , Extend the service life of X, Y, Z axis guide rail and lead screw.
1. Check the contamination on the surface of the reflector and focusing mirror irregularly (at least once a month) depending on the environment of the workshop, and clean the optical lens in time to ensure its service life (see the maintenance of the optical lens for details).
2. Regularly clean up the debris over the air outlet to ensure the ventilation effect.
3. Regularly check the filter in the air circuit, and remove the accumulated water and debris in the filter in time.
4. Regularly check whether the screws of the travel switch bracket and the striker bracket are loose.
5. It is necessary to clean up the dust on the filter net of the ventilation fan of the electric control cabinet in time to ensure good ventilation, so as to facilitate the heat dissipation of the internal electrical components.
6. Clean the body of the bed in time to prevent debris in the protective leather cavity of the guide rail, so as not to damage the guide rail, thereby prolonging the service life of the guide rail.
7. After the machine tool is installed and used for a period of time, the level of the machine tool should be readjusted to ensure the cutting accuracy of the machine tool. The reflection of the mirror and the focusing of the focusing mirror are completed together. There is no offset problem of the focusing mirror in the optical path, but the three mirrors are fixed by the mechanical part, and the possibility of offset is high, although it usually does not occur. offset, but it is recommended that the user must check whether the optical path is normal before each work.
