Single edge spiral milling cutter is recommended for acrylic cutting. It is characterized by smokeless and tasteless processing, high speed, high efficiency, no chip sticking, and truly environmental protection. Its special manufacturing process ensures that acrylic is processed without cracking, extremely fine knife lines (even without knife lines), and the surface is smooth and smooth. The machined surface shall reach the sanding effect, and it is recommended to use double edge three edge spiral milling cutter.
For density plate cutting, it is recommended to use a double edge large chip removal spiral milling cutter. It has two high-capacity chip removal grooves and a double edge design, which not only has a good chip removal function, but also achieves a good tool balance. When processing medium and high density plates, it does not blacken, does not cap smoke, and has a long service life.
Single blade special aluminum milling cutter is recommended for aluminum plate cutting. It does not stick to the cutter during processing, with high speed and efficiency.
For precision small relief processing, it is recommended to use a round bottom carving knife.
Cork, density board, primary wood, PVC, acrylic large deep relief processing, single edge spiral ball end milling cutter is recommended.
It is recommended to use single edge and double edge upper and lower milling cutter for cutting without burr on the upper and lower sides.
